Subject: Ellison type pressure regulator for slide throttle
From: Rotary Engine
Date: 12/14/2010, 10:11 AM
To: AAA Put this in the To box

I notice that Ellison does not use the Tillotson
needle valve. I think they make their own.
It is much shorter than the Tillotson part so
the pressure regulator is much smaller over all.

It consist of two transparent balls in a brass housing.
The small one does the fuel sealing and the larger one
about .25 to .375 inches in diameter presses on the smaller
one to close the fuel supply valve. The small one is just
a little bit larger than the fuel orifice which is about
0.1 inch diameter. Say .125 inch in diameter.

The housings is easily made from a NPT brass hex plug
by simply drilling a couple of holes.

Here is a source for the balls.
http://www.smallparts.com

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.