Subject: Ellison type pressure regulator for slide throttle
From: Rotary Engine
Date: 12/16/2010, 8:09 AM
To: AAA Put this in the To box


I notice that Ellison does not use the Tillotson
needle valve. I think they make their own.
It is much shorter than the Tillotson part so
the pressure regulator is much smaller over all.

It consist of two transparent balls in a brass housing.
The small one does the fuel sealing and the larger one
about .25 to .375 inches in diameter presses on the smaller
one to close the fuel supply valve. The small one is just
a little bit larger than the fuel orifice which is about
0.1 inch diameter. Say .125 inch in diameter.

The housings is easily made from a NPT brass hex plug
by simply drilling a couple of holes.

Here is a source for the balls.
http://www.smallparts.com

Paul Lamar


Hi you guys

I took some pictures of the Rotec, but my computer craped out, and I send
them if I can retrieve them.##

BUT it occurred to me that their is a device that is almost exactly what we
need for the Elision type regulator off the shelf for not much
dough..........................................with or without a built in
filter and your going to need at least a last chance filter with all those
tiny holes  (sorry I mean calibrated discharge holes)

Anyway here is the patent to look for I was unable to download as a PDF
United States Patent 3695438
this is for the filtered version.

Clive.....................


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.