Subject: Renesis in an RV-7
From: Rotary Engine
Date: 12/17/2010, 10:20 PM
To: AAA Put this in the To box


 Paul,

 Check out pages 9-11 in this issue of the RVator:
 http://www.vansaircraft.com/RVator/2010/1-2010-RVator.pdf
 Look at the [intake]  manifold and the muffler.

 Steve Brazil

That intake manifold is called a dynamic chamber. It was invented by
Mazda to increase torque at 3000 RPM. Very important in a car engine
but kind of useless for a aircraft engine that cruises at 4500 to 6500 RPM.
In effect it doubles the length of the runners.

The early "standard" intake system mentioned in some of the illustrations
was pretty bad as it had runners of different lengths fed by a 4 barrel
carb so just about anything tuned properly would be a improvement.

This was a point many  people over looked when dynamic chambers
were all the rage. It was like comparing apples with oranges.
Mazda PR did a good job of selling it :) Just about all modern
engines use simple tunned intake manifolds with equal length
runners.

You want the torque to peak at the cruise RPM as that gives
the best BSFC or lowest fuel burn per HP.

The very complicated stock RX8 intake manifold is the same thing
except it has more stages as it goes all the way up to 9000 RPM.

Tracy was the first to build one for an aircraft engine but then
he gave up on the idea when he went to the RX8 engine and used
simple equal length runners. That is when he went 217 MPH in
the 100 mile Sun n Fun X country race.

I suspect most people have given up on the idea for aircraft
use but there still could be some die hards out there:)

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.