Paul,
I recently obtained a water block for my Renesis engine from Jeff
but it doesn't have the collar which fits on the top as shown in your
news letter. He tells me that you are the source for this. Please send
me the details as to cost and availability. I also found that the water
block does not have a provision for clearance for the top bolt that
holds the apex seal oil pump and needs to be modified with a relief to
clear it.

Rolland LaPelle

I am sold out. Just sold my last one.

This one is close but a bit over size by .040".
http://www.docsblocks.com/products.asp?cat=84&pg=2

If you need it cut down buy one and send it to me.
I'll cut it down in my lathe to fit.

I lost track of the original source.
The base was 57 mm in dia and 5 mm thick as I recall.
In the mean time I will keep looking.

------------------------------------------------

I just double checked. That one should fit. If not
let me know.

Paul Lamar