snips.....
Can EDM be used to drill the .012" dia holes in the Ellison tubes?
Joe Berki
Limo EZ
Not to worry about the inch :)
EDM is a great idea. I'll have to talk to my local EDM guy.
Paul Lamar
Could concentric tubes be used to make the small fuel delivery holes?
The idea is that you would drill a pattern of holes using a more
practical drill size. Make the holes while one tube is inserted
inside the other. Then slide (index) the tubes so that the
effective hole size is made suitably smaller. This is like a tiny
slide throttle for the fuel.
You might even be able to devise a mechanism to adjust the effective
orifice size while in flight - a different type of mixture control.
Downside is that you might have to use a somewhat larger diameter
large tube in order to flow enough fuel.
Matt-
That is a nifty invention Matt.
Paul Lamar
Matt, Welding supply houses sell in addition to the file type torch tip
cleaners another type that are small drill bits. If you use your
external tube idea with a more manageable hole size drilled in it you
could then use it as a jig to locate the smaller tip cleaner drill bit
to drill into the spray tube with an air drill motor. This would also
make identical hole patterns in the spray bars for both rotors.
george grimes
Matt,
This reminds me of the slits used in K-jetronic fuel injection fuel
distributors where there is a piston/plunger sliding inside a thin
hardened steel tube that has long slits allowing the fuel to pass
separately into each injector tube in increasing amounts as the piston
slides upward from total closed position.
http://tinyurl.com/2dht5do
See page 19 in the pdf.
Ed Carver
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.