Right now I am avoiding the intense rain here and am researching
engine
stuff indoors.
I can easily mill the hole when I get ready, I have a couple
expendable
housings that will work if the sweat is successful. IMS is down the
street if I need materials and I have a lot of that already. It's a
month or so down the road before I get into this particular project.
On a different note, I am learning how to do aluminum castings. I am
looking for the best casting material for center and end housings,
possibly one to the ceramic metal matrix hyper alloys and
beralcast 363
for rotor material. It appears to be the only beryllium alloy on the
market and can be investment cast to near net. Do you have any
knowledge
on this stuff? I've been reading about it for about a day, and
looking
for a supplier.
Ed Carver
I have heard of aluminum/beryllium alloys .70% the density of
aluminum.
Makes great rotors. What is the density of beralcast 363?
Paul Lamar
The spec related text is from the below link:
http://www.mdatechnology.net/techprofile.aspx?id=403
--
GENERAL BERALCAST® ADVANTAGES
Advantages over Aluminum
* About 22 percent lower density with essentially equivalent
strength to A356 aluminum
* About 3 times stiffer (modulus of elasticity in tension)
* 2 to 4 times more dimensional stable than aluminum
to 10 times better in damping coefficient for stability and jitter
reduction depending upon the driving resonant frequencies.
* About 30 percent lower in coefficient of thermal expansion (CTE) for
matching of mating parts.
Advantages over Beryllium
*About 3 times greater ductility than hot pressed beryllium with
greater damage tolerance
*Castable for complex and precise net shape configurations
*Weldable for defect repair
*Reduced scrap generation, machining and environmental process
concerns. Does not require post-machined chemical milling
*About 1/4 the raw material input cost [of what?]
Sounds like the solution to the need for a better/lighter A356 alum.
Tomorrow I might be able to get a cost and availability on this stuff.
Ed Carver
Sounds like alloy to me. What is the cost?
Paul Lamar
It is certainly aluminum/beryllium.
Here's a better link with engineering specs:
http://tinyurl.com/37tmrwf
The lower raw material input cost of beralcast is relative to the cost
of using a much purer form of beryllium. The low alloy pure beryllium is
either formed from a powder, or is cut from a large billet. Both of
these methods have serious tooling issues to form the final surface, so
much so that it greatly increases production costs. The beralcast alloy
is much cheaper due to it's alum content and ease of production compared
to beryllium.
Everything I have read tells me it is a material as easy to handle and
shape as the A356 alum.
I can't find an active email address to request a quote for material.
I'll try to call tomorrow. If I can get my hands on some of this stuff,
I will figure out how to make a casting and take it down to a local
foundry and have it poured, vacc'd, or pressure cast. We'll just have to
figure out where in the rotor we may need to increase thicknesses.
Ed Carver
If this is true it could double the max RPM and HP of the rotary.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.