Subject: best casting material for center and end housings
From: Rotary Engine
Date: 12/23/2010, 7:35 PM
To: AAA Put this in the To box


Dale,  I wouldn't classify housings that cose $2650.00 apiece for end
housings as cost effective. As a basis for a four rotor I am not
comfortable with the series cooling at continuous 6400 RPM. Using
390 or 398 alloy housings no coatings for wear are needed. This
material (390) is used in lawn mower engines and despite the post
last week that it wasn't successful in the chevrolet vega it was.
The problems with the vega were a result of cost cutting on the part
of GM where they used a much too small radiator and other cooling
system problems. With no maintenance of coolant level there were
overheating issues. During overhaul after overheating it took a 3
step process to restore the cylinder bores that was ignored by
amatuer mechanics in favor of the methods they used for cast iron
blocks. Imformation on the vega durability and cooling problems are
easy to access in yahoo or google.

          To produce a two piece end housing with coolant flow paths
(parallel cooling) as well as increased flow rates and including
mounting provisions is not that difficult. The housings can be faced
off in a large lathe and lapped. The lathe approach allows boring
the stationary gear bore and some "O" ring seats while it is chucked
up for accuracy. "O" ring paths for rotor housing seals can be done
in a CNC router. If I didn't have the machine tools I could farm out
everything with an end cost of $700 for the front or center housing
and $850 for the bellhousing end. I drew mine up with a front and
rear bellhousing which are dowel alligned so that two sets of RX8
internals can be used for a 4 rotor. As a six rotor the prop end e-
shaft would need modifications. If I farm out the foundary casting
at $140 and buy the "O" rings for $90 which includes double sealing
the water to oil seals at the stationary gear I can build them for
$250 apiece. That would be about $1500 for all the housings of a
four rotor.

george grimes


George,

You are right on the Vega problems, lack of proper maintenance. They just had
to get hot once and the pistons expanded too much. This wiped the tin coating
off the skirts. The Al big blocks used in the COPO cars and CanAm race cars
used the same technology.

Sounds fair on the cost angle if you can do it. I do hope you can work it out.
The Al rotors may not be a good idea if using the high silicone castings for
the same reasons as the cars. Possibly Ti rotors would be advantagous. I think
I remember something about some one in Russia being able to cast Ti rotors.
Likely not cheap though.

Dale Davies


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.