Subject: best casting material for center and end housings
From: Rotary Engine
Date: 12/26/2010, 9:11 PM
To: undisclosed-recipients:;


 Dale,  I wouldn't classify housings that cose $2650.00 apiece for end
 housings as cost effective. As a basis for a four rotor I am not
 comfortable with the series cooling at continuous 6400 RPM. Using 390 or
 398 alloy housings no coatings for wear are needed. This material (390)
 is used in lawn mower engines and despite the post last week that it
 wasn't successful in the chevrolet vega it was. The problems with the
 vega were a result of cost cutting on the part of GM where they used a
 much too small radiator and other cooling system problems. With no
 maintenance of coolant level there were overheating issues. During
 overhaul after overheating it took a 3 step process to restore the
 cylinder bores that was ignored by amatuer mechanics in favor of the
 methods they used for cast iron blocks. Imformation on the vega
 durability and cooling problems are easy to access in yahoo or google.

 To produce a two piece end housing with coolant flow paths
 (parallel cooling) as well as increased flow rates and including
 mounting provisions is not that difficult. The housings can be faced off
 in a large lathe and lapped. The lathe approach allows boring the
 stationary gear bore and some "O" ring seats while it is chucked up for
 accuracy. "O" ring paths for rotor housing seals can be done in a CNC
 router. If I didn't have the machine tools I could farm out everything
 with an end cost of $700 for the front or center housing and $850 for
 the bellhousing end. I drew mine up with a front and rear bellhousing
 which are dowel alligned so that two sets of RX8 internals can be used
 for a 4 rotor. As a six rotor the prop end e-shaft would need
 modifications. If I farm out the foundary casting at $140 and buy the
 "O" rings for $90 which includes double sealing the water to oil seals
 at the stationary gear I can build them for $250 apiece. That would be
 about $1500 for all the housings of a four rotor.



 george grimes


 george

 Since it is almost the new year and predictions are made around this
 time...  I predict that if this works as good as you say, you will be
 too busy selling housings to get much done on your plane!!  When can I
 buy a set for my single rotor?

 Dan F


 I would be interested in buying a set for a two rotor. So $1500 for a 4
 rotor
 works out to $300 per end or center housing roughly. $600 for a one rotor,
 $900
 for a 2 rotor. Bring it!
 C. Smith

 It is a lot easier to design and build if you make them for
 p-port only with a hard steel wear surface. The Racing Beat
 versions are for side ports and therefore more complicated.

 Paul Lamar


That is what I have in my single rotor.
Richard Sohn
Richard Sohn <res12@fairpoint.net>

Here are a bunch more pictures of Richards project
for the new guys.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.