Tracy recommends cutting off part of the coil around
the connector and soldering wires on to the pins.
Page 23.

This will work of course but there is a better
way. It is called a Molex socket.
No need to saw off part of the connector on the coil.

They are made in at least two sizes.
The .093 is a bit big but the .063 works fine.
Just solder a wire to the socket outside the coil
and install them with a pair of needle nose plier.
Then fill the cavity with RTV or Epoxy if you wish.

Paul Lamar


Geesh, just use the OEM connector; $4.50

GM LS1 D580 IGNITION COIL CONNECTOR (Unassembled) - eBay (item
290512403043 end time Jan-12-11 17:56:49 PST)
http://goo.gl/b54zl

BrianG
Iowa

Thanks Brian for finding those. That was on my short list.

Please see if you can find some for the RX8 coil.
Paul Lamar