Tracy states on his web site that his MAP system will
not work with the Power Sport P-port butterfly valve
in the rotor housing trick. I am inclined to agree
with him but I don't think he has considered the
apex oil seal hole for the pressure tap location.
That is the only place to put it if you are
using a slide throttle p-port. In other words
don't use an oil injection metering pump. Obviously!
Mix apex seal 2 cycle oil with the fuel and your
engine will be much easier to tune using a manifold
pressure sensor not to mention one less thing to
deal with or fail.
There are a lot of old rotary engines
in junk yards after the small nylon lines feeding
apex seal oil to the rotor housings became
brittle and cracked. If you have a rotary powered car
check them frequently and replace them after ten
years. Mazda should have used steel brake
line tubing years ago.
In fact not putting the pressure taps in the apex
seal holes leads to this kind of mixture map IMHO.
They are all over the map pardon the pun. IMHO this is
one reason Tracy's computer is so hard to tune.
We are still collecting data on this subject so send
us your mixture maps with and without the taps
in the rotor housings.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.