Tracy recommends cutting off part of the coil around
   the connector and soldering wires on to the pins.
   Page 23.

   This will work of course but there is a better
   way. It is called a Molex socket.
   No need to saw off part of the connector on the coil.

   They are made in at least two sizes.
   The .093 is a bit big but the .063 works fine.
   Just solder a wire to the socket outside the coil
   and install them with a pair of needle nose plier.
   Then fill the cavity with RTV or Epoxy if you wish.

   Paul Lamar


   Geesh, just use the OEM connector; $4.50

   GM LS1 D580 IGNITION COIL CONNECTOR (Unassembled) - eBay (item
   290512403043 end time Jan-12-11 17:56:49 PST)
   http://goo.gl/b54zl

   BrianG
   Iowa

   Thanks Brian for finding those. That was on my short list.

   Please see if you can find some for the RX8 coil.
   Paul Lamar




I don't have any rx8 coils to try; but maybe it's just the 3 pin
version? (looks like 4pin is the D580 connector)

http://whiteproducts.com/sealed150.shtml
brian gochnauer