Are you a pattern maker Ed? If so I might have some work for
you. Most pattern makers using traditionally materials charge a lot
of money for their art. It is a dieing breed as most new
casting patterns are made in NC machines. Core boxes are
particularly difficult to make as the wall thickness is very
difficult to control. I know. I have been there and done that.
Rhino 3D helped greatly but the biggest help was the
stereo lithography machine at Ventura College :) No longer
in operation unfortunately.
Paul Lamar
Before this particular thread took off, I was under the impression that
we, the average engine builder could not easily have reproduced at
any local chrome shop, the thin lining on the steel liner. And, that
if nasa could not successfully apply a coating of silicon carbide on
the alum surface they created, then probably we could not do it either.
nasa obviously chose a poor apex seal for testing. Shame on them,
they should have known. Taxes down the tek toilet again.
For us, striking out into this difficult issue of developing confidence
in a chosen liner, we otta stick with what we know works for the
long haul.
Bob Rowley, we would love to see how you determined proper ram air
system on your bikes. This could be taken a long way on aircraft.
Also, I cannot picture what you are referring to in your 'dragging
cool air into the exhaust with the exhaust ejectors'. Thank you!
Anyone know of a shop that has successfully applied/reapplied chrome
on a Mazda rotor housing? and made it so that it will last?
Paul, I don't mind sounding naive, (happens regularly), the
production of an intake manifold is something I have considered many
times. I watched a youtube about a prototype shop building a V8
manifold down in Oz. Did'nt appear so tough to do, just gotta have
the correct casting sand with binders, and an oven.
Could I do it? I'm not a mold maker. I don't see why I could'nt.
Anyone out there have, or know someone who has, an induction furnace
with a crucible that will handle about 20lbs? It's really amazing how
inexpensive and small, these hi freq furnaces have become. Cheaper than
my syncrowave.
Ed Carver, ex moto pilot
Check my book How to Cool Your Wankel on the exhaust ejectors
Ed. AKA Augmenters. Page 63.
Paul Lamar
Check RX7 Specialties web site. They are out of Calgary ('88 winter Olympics;
the Jamacan bobsled team and Eddy the Eagle), Alberta, Canada. Advertizes
Cermet replacement and the two piece wide housing for 3 and 4 rotors with Cermet.
Dale Davies
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.