Roger,
This is cheaper than the ABS sensor and works
better. Klause has been using these for years.
I cut the trigger wheel with a large hole saw :)
Paul Lamar
Paul,
Been studying the hall effect sensor, and it seems to be the best
approach, however, the interface wiring and circuit that will integrate
the Hall Effect into the 555 is a bit unclear, I am clear of how the
Hall Effect sensor works, but reading from the text, an amplifier is
mentioned, and on the first pic there is a pic of a coin, , hall effect
sensor, and a chip.
That chip, is that the amplifier?
Where do you wire up the coin?..... :)
Roger
No interface circuit required. Puts out a beautiful negative
going pulse. Just what the 555 wants. See the scope picture.
That chip has no relevance to a 555 circuit. Sorry! It is used with
CD ignition systems and can be triggered directly by the hall
effect sensor. When you get a chip part number like that you
just put the part number in google and it will tell you
all it knows about it. (a lot) :)
ST is the maker's logo and L6384E is the part number.
All the Hall effect sensor requires is one 10K resister
connected to 5 volts. As in the picture of the prototype
board. The color code of the resistor can also be found
on google. I don't know how I got along with out google. :)
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.