Subject: Aluminum rotors.
From: Rotary Engine
Date: 1/6/2011, 4:16 PM
To: AAA Put this in the To box


 I have a suspicion that an all alloy rotor would have problems
 with keeping the fit of the pressed in e-shaft bearing with the rotor
 expansion and contraction due to temperature. I was considering using
 what I would call a flanged sleeve made of steel to mount the bearing
 and stationary gear. The stationary gear fits into the face of the
 flange, the bearing in the bore, and the alloy rotor fits over the
 outside of the sleeve with dowel pins into the back side of the flange.
 It doesn't appear too dificult to CNC the negative patterns to cast the
 wax as a left and right side with the wax sections keyed together. The
 difficult part is machining the side seal grooves which was a major
 stumbling block for rotamax. I was thinking of a router motor swinging
 in the proper arc over an indexing table but reading how much trouble
 others have had with this it is obviously not that easy. Useing 398 for
 the rotor doesn't seem to be a problem as far as galling with side
 housings of the same material because the side inner and outer oil
seals
 keep the parts separated. Temperature control of the rotor might
require
 a modified control of an increased oil flow thru the rotor from the
 stock Mazda design although a prototype  of the stock type would be
 tried first. Alloy parts with different compression depressions would
 reuse the same flanged sleeve.


 george grimes

 There is a steel insert in Jeff's design for the rotor bearing.
 The side seal grooves are a piece of cake for an NC mill.
 Mazda mounts 3 rotors on a pallet and rotates the pallet to cut
 three groves at a time with a broach.

 Paul Lamar Graduate of a course in NC machining :)


Yes, there needs to be a greatly increased oil spray directly on the
inside of the rotor, accompanied with a powerful vacuum to draw it out.
This should greatly reduce temps. I think a dual oil pump may need to be
used.

Does anyone think the Beryllium/alum cast rotor idea can't work?

Ed Carver


I am presently drilling into the issue of obtaining a small quantity of
the beralcast 310 and the nasa 398. Starmet is the exclusive vendor for
the beralcast, and a salesperson is kicking the ball back and forth with
me. I have contacted one of the nasa employees about a direct vendor for
the 398.

Normal alloy vendors sort of give me the blank stare when I ask them
about these materials. Never heard of them.

George, have you found a vendor for the 398?

Ed Carver


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.