As you are setting up the test engine, I would like to suggest a
couple of ideas which grew out of my study of your excellent work in
measuring MAP using the oiling holes, along with the improbable injector
maps others have arrived at for Tracy's ECx computers. Your
measurements showed the enormous variations occurring for each
combustion cycle.
I believe it is likely that these variations,
transmitted through small tubing, account for drastic variations in
measured pressure as standing waves are set up in the tubing which move
with rpm changes. The standing waves either add to or subtract from the
average pressure, and as rpm changes the measured pressure varies.
I first recognized problems in electronic measuring of MAP several years
ago when I bought an electronic engine monitor from one of the first
small vendors fo such items, and found MAP readings not in agreement
with my mechanical gauge. I tested both on the bench with our altimeter
calibration equipment, and they agreed. In the airplane, at low
altitude one read 20.0 when the other read 21.5. At higher altitude,
the error was reduced.
I added a restrictor to the MAP line, and the
error was further diminished. I was surprised at the degree of
restriction required to eliminate the error. My assumption was that the
system used an algorithm that produced a stable but inaccurate reading
for a varying input. A couple of years later I installed a Dynon engine
monitor in another airplane, and found the MAP reading very jittery. It
appeared they rapidly read and display a couple times a second, and each
sample varied from the previous.
Again, a restrictor solved the problem
Teeing the two pressure taps of a rotary does not eliminate the problem,
although it might reduce it. The very sharp drops in pressure during
intake mean either a very tiny hole in the tap or a substantial volume
in the lines will be needed to provide a stable pressure free from the
effects of standing waves. A separate line and accumulator to each MAP
sensor of the EC2 might be the best solution.
If my deductions are in error, perhaps some of the engineers here
familiar with fluid dynamics can set me straight.
Victor
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.