Subject: P-Port finishing
From: Rotary Engine
Date: 1/9/2011, 8:30 AM
To: AAA Put this in the To box

 Took about 2-3 hours per housing. Dremel tool, abrasive disk,
  sanding drum, coarse and fine cratex wheels. Checked for
 interference with starret machinists scale.

 C. Smith

 A Dremel tool is a bit under powered :)

 Paul Lamar

 Hmmm. Not sure what you mean by that. I'll say this, the dremel
 never got away from me and nicked the liner anywhere I didn't want
 it to. Die grinders, and other high speed pneumatic rotary tools do
 that to me all the time. 8-O
 C. Smith

 I have watched a pro do it. John at Mazdatrix. In his 40 years
 working with rotaries he has probably ported a thousand end housings
 :) He makes a wood clamp to securely hold the rotor housing and then
 uses two hands on the die grinder. Takes him 15 minutes :) The other
 secret is you use grinding stones and those sandpaper wrapped
 sanding drums. Less "catching" than a bur.

 Paul Lamar


 Another tip I have found is to use light pressure. Let the burr or
 stone and
 the speed do the work rather than leaning on the grinder to make it
 go faster.
 It is called finesse. You found out it works on women years ago.

 Dale Davies


 First of all, I do not have the benefit of having 40 years of
 experience with
 rotaries and porting thousands of housings. My experience prior to
 this was
 zero. Nor do I have the luxury of unlimited finances. My investment
 so far in
 each housing at this point is somewhere around $500. I cannot afford
 a mistake.
 Therefore I chose to proceed with great care and caution. I used a
 lot of
 finess, perhaps why it took 8 to 12 times longer than the
 professional with 40
 years of experience, and I always use 2 hands on my rotary tools.

 I used the tools and materials I had at hand, my hangar is currently
 about 11
 degrees F which is where my compressor is, another reason I used a
 dremel. In
 spite of my lack of professionalism, I was successful in that I
 believe the seals will make it past the port without being damaged
 or excessive wear. In that respect, I am quite satisfied that the
 time and effort was worth it.
 Your results may vary.
 C. Smith

 11 F heck? I would not have been there C :)
 I would be home by the heater. I am too old for that.
 That shows real dedication.

 Paul Lamar


Paul,

I've now done a few rotor housings now, but not thousands by any means.
I purposely position the tube a little below the chrome surface for
welding.  My intent was to have a step where I could fill with filler
rod while keeping the minimum amount of weld bead above the seal
surface.  I can then clean up and radius the weld without causing leaks.
So far, that approach has worked well.

As for grinding the weld, the less there is to grind, the less chance of
having the grinder get away from you and damage the housing.  If you
grind too much, you end up with a pinhole leak.  Caution and patience is
the rule of the day.

Mark

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.