Subject: Aluminum rotors.
From: Rotary Engine
Date: 1/10/2011, 1:37 AM
To: AAA Put this in the To box



   Hi Ed;
   IIRC, there were early RX-8 rotor failures in racing due to thinned RX8
   rotor interior ribs.

   The current 13B engine has lots of pluses with the soft cast iron
   rotors.
   I think a lot people would be interested in the 10-20+# weight savings
   on the rotors, counterweights, eshaft, flexplate  You might get the
   weight of the core under 100#.
   Lighter rotors might double the rpm and HP limit for racing folks.
   Aluminum rotors sound like a good experiment.  The Al/Be sounds even
   better.  Definitely worth a try.  Few people have tried to replace the
   rotor.

   Like some of Paul, Bill and Dale's comments -
   Aluminum rotors have several disadvantages including lower
   strength/stiffness at temperature leading to early seals failures,
   higher CTE increasing the chance of seizing in overheat or oil/coolant
   loss scenarios, poor wear resistance without heat
   treating/anodizing/hard anodizing - not sure how that would affect
   things.  I have heard of many blown rotor and complete oil/coolant loss
   stories where the engine still made it home.

   David Mathes was investigating AM-SC1 as another iron replacement
   years ago.
   Al-SiC http://www.mc21inc.com/ looks like a cast-able replacement with
   properties closer to cast iron.
   Lots of ceramic/cermet out there:  Sialon, Si/N, C/C, C/SiC.  More
   exotics on the horizon.  Mcubed.

   Some of them can be near cast to reduce or eliminate finish machining.
   If I were you, I would literally copy an existing rotor to maintain
   compatibility with off the shelf parts.  Lightening the eshaft, cw and
   flexplate is easy enough.  gears are cheap and readily available,
   increased oil flow and pressure as well.
   Iron end-housings are another obvious weight savings target.  Integral
   redrive, delete the 2nd gen CAS, lighter water pump. lightweight
   exhaust, reduced flexplate/ring gear/permanent magnet alternator...

   Cheers
   Cary

   Nebraska Doug, If I can get the stuff, I will definitely try to push
   it through. Is there some reason why you like the 363 over the 310?
   IBC/beralcast may only sell to us if I use them to cast it.


   Cary, there will be considerable design changes whichever light
   alloy we use. The external dimensions will remain the same. The
   internal webbing will not. That will be modified to spread out the
   stresses, and to improve flow of the oil form one side to the other.
   I'll check out the ceramic stuff tomorrow.


Ed Carver



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.