There was a post by (George?) or someone else, intimating that
they were going
to make some light weight center and end housings for much less
than half the
cost of Racing Beat product. These would be P-Port only.
I have a serious interest for these, and as we are pretty much
all building
P-Ports, there should be a significant and immediate demand.
Probably more so
than a light weight rotor, as there are fewer technical issues
to prove out.
If there is a real effort to move forward with these, I would
like to throw
support that effort in any way I can.
C. Smith
I agree. That is a very worth while thing to do.
Paul Lamar
C Smith, I have something like 18 different parts designed. By
selecting three housings and the corresponding wear plates a 2 rotor
or three rotor module is assembled. Substituting the front
bellhousing option for the rear engine joins two two rotor modules
for a four or six rotor. Adding to the mix there are side housings
for P-port and for side port. The wear plate is intended to be
390-17 aluminum or if available 398 for the higher strength. A front
or intermediate wear plate can be substituted with dynafocal
mounts. There is one for the P-port and one for the 8 port (side
port) versions. All the parts are interchangable except when the low
mount chrysler water pump front housing is used. This part is not
compatable with the dynafocal mounts. The stock appearing front
housing can use a Mazda water pump. I will try to attach a few JPEG
images. Notably the joint between the wear plate and it's side
housing have tripple "O" ring sealing. I will send a second post
with a few more screenshots.
george.grimes
Back again, I have solids in .3dm and can do .stl or .step versions
of both the patterns (with machining allowances) and the finished parts
with "O" ring tracks and groves. The finished machined files could also
be used to do CNC versions of the parts. As a CNC version You would
probably need to do the wear plates in iron for nitriding. The two piece
housings are all meant to be bolted together with the included "O" ring
provisions for sealing. It might also be possible to bond the parts
together with adhesive but the "O" rings seem more reliable to me.
Notice the side ports have all the kinks sorted out. The ports are
mostly CNC machinable with the two plates separated except for a 1/4"
thick bulkhead across the wear plate which is not reachable with a 3
axis mill. This would be left as cast for a P-port to seal off the side
housing. There are also fuel injection mounts for Bosch injectors which
point straight thru the port into the rotor housing. If you care to CNC
out a set of test housings I can send you the files. Just let me know
which water pump and mount you want and the number of rotors. (maximum
is six rotors) I also have the pattern files sliced into individual
files for making a stacked up pattern from MDF to cast permanent
patterns. I could send you the whole lot of it on two DVD with support
drawings of fastener locations. There are additional 5/8" tie rods
added. The wide housing for the three rotor was in progress when I
stopped to put up the hanger and install machine tools. I don;t know if
the ports are the final version and I decided it needed a counterweight
and hadn't designed that yet. These parts were all designed to be cast,
then bored and faced off in my lathe which swings 26" The "O" ring
tracks require CNC where the two parts join.
george grimes
I would be very interested if these components become available. What is
proposed for the wear surfaces?
These should make a single rotor more viable for the 100Hp bracket.
John Evans
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.