Subject: Visit to Mazdatrix RX8 coils
From: Rotary Engine
Date: 1/11/2011, 6:43 AM
To: AAA Put this in the To box


 Mazdatrix  have plenty of genuine Mazda 3rd gen RX8 coils
 in stock. Mazda part number N3H1-18-100B-9U. A bit more
 expensive than the RX8 after market versions.

 They are also selling the GM LS2 coils with a mounting
 bracket for RX8 engines and a 5 MS dwell. In racing applications
 they are going to 10,000 RPM and above but only for a
 fraction of a second and then it is time to shift.
 Then it happens again. In drag racing it is all
 over in ten seconds or less. In road racing
 I suspect most rotary guys are still using CD MSD's.

 They use Haltech EFI's and one can set the desired dwell
 in that device. The Haltech seems to be the EFI of
 choice in rotary racing.

 This duty cycles is typical of automotive use
 so the inductive coils don't get a chance to over
 heat so much.

 In that regard the LS2 with heat sink seems to
 be more durable. It takes 5 ms to fully charge
 the LS2. At 8000 RPM the coil duty cycle is 62.5%.
 This is far higher than the duty cycle you will find
 in a truck as the coils fire every other revolution.
 The amount of heat and current the coil needs
 is a direct function of this duty cycle.

 In theory the RX8 coil should be designed
 for this duty cycles as it fires every revolution
 but only occasionally. Most of the time you
 are cruising down the freeway at 3000 RPM.
 The RX8 coil is fully charged in 2.6 ms because
 it has lower primary inductance. However the max pulse
 current is higher.

 In aircraft use the coil duty cycle is higher
 than a car duty cycle so a heat sink should be used
 with RX8 coils.

 How many people are planning on using RX8 coils?

 I am thinking of building a heat sink for RX8 coils.

 Paul Lamar


Hi Paul

I planned to use the RX8 coils on a heatsink built into the water radiator intake diffuser wall and blast tube to to coils themselves. Perhaps overkill.

Cheers

Steve Izett

Sounds like a good plan. I think the coil temperature
should be kept well under 100C. Use a heat sink and a small
12 volt blower if necessary. I am working on a design too.
I notice the guys running the 3 rotor in the Rolex are
using a crude home made heat sinks.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.