Too bad I cannot find a chemical to dissolve the epoxy
potting compound in failed RX8 coils. I'll bet they are
a dime a dozen. I could use them with a separated IGBT
switch :)
Paul Lamar
This goes way back to a new job I started (fall of '66 I think) where I
attended a demonstration where a chemist had modified an old overhead
projector to allow viewing reactions normally done in small test tubes,
projecting them on a screen for huge audiences to observe. He had
fabricated square test tubes to eliminate refraction and allow clear
imaging of test tube contents. The test tubes were constructed of epoxy
cemented glass plates. The chemist was using a wide variety of chemicals
without any problems. I remember him mentioning that he had problems
with one chemical attacking the epoxy - and I think he said "Formic
Acid". I know that formic acid is the stuff that burns you when one is
bit by an ant, but that about covers my experience with the stuff.
R
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.