Subject: dissolving epoxy coil potting compound
From: Rotary Engine
Date: 1/11/2011, 9:53 PM
To: AAA Put this in the To box



 Too bad I cannot find a chemical to dissolve the epoxy
    potting compound in failed RX8 coils. I'll bet they are
    a dime a dozen. I could use them with a separated IGBT
    switch :)

    Paul Lamar


This goes way back to a new job I started (fall of '66 I think) where I
attended a demonstration where a chemist had modified an old overhead
projector to allow viewing reactions normally done in small test tubes,
projecting them on a screen for huge audiences to observe. He had
fabricated square test tubes to eliminate refraction and allow clear
imaging of test tube contents. The test tubes were constructed of epoxy
cemented glass plates. The chemist was using a wide variety of chemicals
without any problems. I remember him mentioning that he had problems
with one chemical attacking the epoxy - and I think he said "Formic
Acid".  I know that formic acid is the stuff that burns you when one is
bit by an ant, but that about covers my experience with the stuff.

R



Hey Paul

If all you are is interested just take a torch to one.  There should be
enough left over when your done to identify what was there before you
put the heat to it.  Sometimes the direct approach is what's called for, no?

Mark LaPierre

I might do that. I have a propane torch I can use.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.