Subject: Alcohol in fuel status.
From: Rotary Engine
Date: 1/12/2011, 7:29 AM
To: AAA Put this in the To box


I had a conversation with a pilot on the alcohol auto fuel
problem in composite airplanes.  He tells me you cannot
get gasoline in Texas without alcohol in the fuel.
Is that true?

Back when I was living up in Northern Ontario our fuel
lines used to freeze because of a small amount of water
in the fuel. We carried Alcohol to dump a small quantity
in the tank and it would immediately find the frozen water
and melt it so to speak. By the time you could get back in
the car the engine would start again.

Water goes to the bottom of the tank. What would happen
if you put water in car gas with alcohol in it and then drained
the water from the bottom of the tank? Would the alcohol come
out as well?

What affect does alcohol have on rubber bladder fuel
tanks?

Paul Lamar



While I cannot speak about the alcohol content of Texas gasoline, I can speak about California gas.  California gas has been laced with about 5.7% ethanol. That number, I believe, went up to 10% recently or will so shortly.  Unlaced gasoline is not available anywhere in California, by law.  Being the owner of a Glasair with integral fiberglass tanks, this was a great concern to me.  My resin system, Derakane 411, is supposed to be suitable for use with gas that has up to 10% ethanol, according to the manufacturer.  It would be important to say here that there are hundreds of different formulations of resin, so each user should check out his manufacturer's specs.

I did some witness sample tests in the 5.7% gas that was available locally. What I found was disconcerting.  The witness samples very quickly developed a surface "scum" (I don't know what the technical term might be) that was easily scraped off and was of a very gooey consistency.  After the initial surface scum was removed, the remainder of the sample was stable.  Clearly there was a thin surface layer of the resin that never fully cured.  One of these samples was taken from a scrap piece of the original factory layups, which was over 10 years old.

My personal conclusion for Derakane 411 is that I will NEVER IN A MILLION YEARS put any alcohol laced gas in my tanks.  While the surface layer was the only affected area, there is a lot of surface area in my tanks and I would never successfully get it out without clogging my fuel filter.  In flight, using ethanol laced gas would be suicide.

There are other formulations of resin that are impervious to ethanol.  I know of one builder that opened big holes in his tanks to coat the tank surfaces with another, ethanol-resistant resin to avoid this problem.  Good luck with that.

I have also heard of some epoxy-based resin systems totally disintegrating in the presence of ethanol.

One of these days I hope that our idiot government representatives will wake up to the fact that ethanol is a stupid, bone-headed solution to the renewable-fuels debate.  I hope it will be soon, but, I'm not holding my breath.

Best Regards,

Steve Thomas

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.