Subject: New MSD coil.
From: Rotary Engine
Date: 1/12/2011, 8:38 AM
To: AAA Put this in the To box



This looks very promising for our use.

The $15,000 GM LS7 V8 is a high RPM racing version with Titanium rods.
Apparently the GM part number "??" is one step up from
the LS2 coils. Hopefully the  dwell time will be more like
the RX8 coil coil 3 ms dwell time.

The coils can be mounted on a heat sink from the looks
of them. That looks like a huge advantage to me.
The LS2 has a small heat sink but it would be better
if it could be mounted on a heat sink which it cannot.

I'll have to get one to look at it and test it.

Paul Lamar

I just talked to MSD and they said the dwell time
is 4 to 4.5 ms which is an improvement on the 5 ms LS2.
Also the bottom is flat so it can be mounted on a heat
sink with two bolts rather than the RX8 coil which only
has one hold down bolt and would require an additional
clamp.

These points seem minor but believe me they
are important. The LS2 cannot be mounted on a heat
sink but it has a very small heat sink on it and
we are attempting to fire it twice as often as it
as it is designed to do and or see's in a 7500 RPM V8.
That means it is drawing twice the current and generating
twice the heat. The V8 cylinder fires every other rev rather
than every rev as in a one rotor.

The icing on the cake is these MSD coils have CD built
in and fire multiple times at low RPM.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.