Subject: Single rotor finally started, not running well
From: Rotary Engine
Date: 1/12/2011, 4:01 PM
To: AAA Put this in the To box



Paul,
Cranked up my single rotor last week.  Using an early electronic ignition. Simply ground off two points of the reluctor, then wired from the dual coils direct to each plug.  Seems to be timed okay.  Spark looks good, but I have not used a scope or anything.

The engine was built by Lou Ross for an early customer.  Hasn't run in a long time, but was well preserved and annually fogged with oil.

Not a P port, but uses two end plates with the larger intake holes.  Mr. Ross calculated approx 120 hp, using a known propeller quantity and static rpm during ground tests.

Using an Ellison throttle body injector.  Initial start quite difficult, as only a few pops and snorts.  Re-timed the engine a bit, but no significant change. Fiddled with the TBI some, increasing fuel flow, with better results, a short rev up and then quit.  Fiddled more and finally sustained a very rough operation at 2400 rpm or so, then quit.  Managed to crack the exhaust mounts in three places in less than a minute, due to the rough operation.  Only intermittent hints of the smoothness I hoped for.

So, a few questions:

Would like to add a flex coupling and improved mount to my nexhaust system. Where do I find the flex joints pictured on the iconel exhaust system at your website?

Is roughness a normal thing for a rotary that has sat for so long?  Could it be due to oil build up or poor induction? Mixture? Etc..?  Maybe the timing is way off?

In efforts to lighten the engine, the Racing Beat end plates look attractive. Any opinion on their longevity in aircraft ops?

Could save a little weight with the P-port.  Do you think there is much realistic power advantage to be found there?  Do you recommend anyone to make the modification for me?  I am not a machinist, and would be happy to pay for the service.

Lastly, I noticed the lightweight alternator on the newsletter.  This is inexpensive weight savings.  Would it be less reliable due to the smaller size? Working too hard, maybe?

I am excited about the engine, but quite new to the whole thing.  Would appreciate any advice you might offer.

Lewis.


Yes Jeff can p-port your rotor housing. See the end of the first
page on the web site. I doubt a side port will generate 120 HP.
It takes 7500 RPM for a P-port to get 125 HP.

What size  Ellison do you have? If it is old the diaphragm may be leaking
and the tiny holes plugged. Take it apart and clean it.
Are you sure the engine is balanced correctly? Contact Mazdatrix and
find out who they use to balance engines. It will have to be disassembled
to do that.

Takes some picture so we can get a look at the exhaust and intake.

I have no cheap sources for Inconel right at the moment.
Just use thicker 321 SS.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.