I had a conversation with a pilot on the alcohol auto fuel
problem in composite airplanes. He tells me you cannot
get gasoline in Texas without alcohol in the fuel.
Is that true?
Back when I was living up in Northern Ontario our fuel
lines used to freeze because of a small amount of water
in the fuel. We carried Alcohol to dump a small quantity
in the tank and it would immediately find the frozen water
and melt it so to speak. By the time you could get back in
the car the engine would start again.
Water goes to the bottom of the tank. What would happen
if you put water in car gas with alcohol in it and then drained
the water from the bottom of the tank? Would the alcohol come
out as well?
What affect does alcohol have on rubber bladder fuel
tanks?
Paul Lamar
Hi Paul
I usually only read ( Thanks) to learn, but I do have some info on this
I have eagle fuel cell bladders, and they are guaranteed to be alcohol
proof. so much so they are rated to be used with pure alcohol fuel for
their entire 50 year warranty period.
I think you are talking about your 182. Who made you bladders ?
and of course Cessna does not allow alcohol in any amount to be used in
their systems.
Do you also have a Peterson STC ?
I so, it comes with a great pamphlet on their finding of alcohol
in Cessna fuel systems ( including O- ring damage etc. )
I believe the alcohol problem may be true in Texas auto fuels. MBTE is
pretty much illegal everywhere, so ethanol is the only other viable option.
check who made your bladders.
Lionel
I don't know who made the bladders. I was mostly interested in
bladders for composite air planes. One could cut a large oval
hole and insert them into the fuel tanks.
No Peterson STC.
I can't use auto fuel anyway as the compression ratio is 9.5 to one.
100 LL only. On top of that I am selling it.
Paul Lamar
I wish it were so easy as to just install a fuel bladder in the composites I
am aware of. The fuel strakes consist of several chambers with "mouse holes"
to allow fuel and vapor between the compartments. They too are composite and
are structural. You would need a bladder in each compartment with a way to
connect the bladders between compartments. There has been some discussion of
fabricating aluminum liners for these birds (Velocity, Co-Z, Vari EZ, Long EZ)
but that would be very difficult and require great welding skills.
FWIW,
Chris Barber
Houston
Apparently the Cessna 182 gets way with out chambers unless they are built
into the bladders. My tanks are long range with 44 gallons per side.
Starting from scratch you could do away with the chambers and thicken
the core in the sandwich skins. Use carbon instead of fiberglass.
Here is a plan for a mid wing fuel tanks. Probably too late for you
but new builders should consider it so they can run auto gas.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.