Subject: How many RX8 owners do we have
From: Rotary Engine
Date: 1/13/2011, 8:02 AM
To: AAA Put this in the To box


 How many people on here have RX8's other than me and Harley?

 Paul Lamar

I own a 2004, 6 speed.

Tom

Have you checked your coils Tom ?

If not an easier way to get them out is remove
the strut tower tubular brace that goes across the
compartment from wheel to wheel first.

I did not do that and struggled getting the air box
and intake bellows out.

I did not take off the throttle body but that
too would be good idea IMHO.

I used every shade tree mechanic trick I could think
of an it is not easy getting them out with out dropping
a coil hold down nut down into the engine compartment.
You will be lucky if they fall on the floor :)

It least one of mine disappeared :)

Paul Lamar


One does indeed have to be careful not to drop one of those nuts
under the bracket where it can't be found (I was thinking that if
I did drop one, and it didn't make it to the floor, I would get
out my Harbor Freight inspection camera with it's magnetic pickup
mounted!) ...luckily, even with my fat fingers, and with my heavy
ski gloves on to keep from freezing the fingers, I managed not to
drop any.

I didn't remove the cross brace, but I did have to cut the tape
holding one of the plastic conduits to the bundle beside the
coils bracket so I could get the wrench and extension in at the
right angle after I had the socket on the nut.

Took me about 45 minutes to change out the 4 coils.

The nuts on mine are flanged, and I was able to use one finger to
hold the flange against the socket as I removed the nut.  This
kept the nut from leaving the socket until I wanted it to. I put
them back on the same way, holding the nut against the socket by
it's flange until I could hand start it with the socket, then
attaching the extension and wrench.

They were quite rusty, so I made sure that I had the socket
securely on the nut before I started torquing it with the wrench.
Before I had started, when I saw the rust, I put a little
penetrating oil on them and let them sit for a few minutes...most
of the rust squeezed or flaked off when I fitted the socket to it
(10 mm socket) and I was able to get the socket down tight
against the nut's flange.

As far as the air box removal, I found that if I loosened both
clamps on the bellows from the air box to the TB, it really
wasn't that hard to get the air box up and out.

Here's a video showing how to get the air box out.  This is the
way I did it, but with the clamps loosened:
www.youtube.com/watch?v=nK38j9IC7L4

This is a pretty small guy, so it might be easier if you're a bit
bigger (dare I say "heavier"?) like I am.

And here is a detailed description of the entire coil replacing
process...
www.rx8club.com/showthread.php?t=168162

Harley


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.