There was a factory recall on this model a couple of years ago,
not sure what
it was all about; however, the people at the dealership said
that everything
was fine. Only challenge I have had is with the engine
flooding, once only,
after I had shut it off before coming up to operating temperature.
What is this with the coils?
Tom
If a coil misfires the rich mixture washes off the apex seal
oil and the apex seals wear out. When this happens you need a
new engine. Once 8 years goes by or 100,000 miles the engine
is out of warranty. You may already have one or two bad coils
as very little power is lost if both bad coils are trailing.
The check engine light may not come on. If the check engine
light comes on stop where you are and have the car towed
or get an OBD II monitoring device.
Paul Lamar
Just to follow up on what Paul said, and repeat myself as long as
we have a captive audience, I was not aware of any problems, but
when I removed my coils, they all had the tell tale burn marks,
and testing them, using Mazda's resistance test procedure, I
found both of my trailing plug coils were dead.
It did show a check engine light earlier this year, but it was
for the O2 sensor...which on hindsight may have been clogged by
the richer fuel/oil mix (I add 2 cycle oil to the gas).
From what I've been reading on the internet, the cars mainly
involved are the pre 2007 models, as Mazda changed to better
coils then.
Harley
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.