Hi,
I was looking at the rear brake master cylinder of a large motorcycle
the other day. It looks like it can be adapted for aircraft use. Would it
have enough stopping power though?
Regards,
Pierre Swanepoel
South Africa
Aircraft brakes are pretty puny, If it is foot powered it should
work. Here are the master cylinders out of my 3000 pound gross
KIS Cruiser. My guess is the piston is 5/8 to 3/4 inch diameter.
Go here and download the catalog.
http://tinyurl.com/46eavla
The pressure built in the brake lines is based on 100 pounds
of foot force and a .5 inch square piston with a 5
to one pedal mechanical advantage is 1000 psi.
Brakes are all about work. Work is piston area times distance.
W = A x D
That is after the pad moves far enough to contact the disk.
My guess for one wheel is .5 square inch master cyl moved 2 inches.
The work product of those two numbers is 1.
Then it all boils down to caliber deflection.
If the caliber piston is 2 inches in diameter
the area is 3.14 square inches.
W = 1
A = 3.14
then D = W / D or .32 inches.
The force on the disc is going to be about 3000 pounds with 1000
psi.
Lets make a couple of assumptions on the coef. of friction.
Lets say it is one for both the tire on the ground
and the friction material on the disk.
If the wheel is 10 inches in diameter and the load on the
tire is 1000 pounds you will need a brake torque of
5000 inch pounds to slide the tire. That will be one G.
If the disk is 6 inch mean diameter and 3 inch mean radius
with 3000 pounds clamping force that is 9000 inch pounds.
More than enough to slide the tires.
OK here is the info we need for real calculations.
What is the weight of the aircraft?
What is the diameter of the tire?
What is the diameter of the brake disk?
And what is the area of the caliber pistons.
From that we can work back and come up with
a master cylinder area/diameter.
According to this web site brake pad friction coefficient
is closer to .5 so our scenario above will only
produce 4500 inch pounds of braking torque.
Still adequate for a .9 G retarding force.
http://www.thebrakeman.com/tbrake_pad_selection
All of this assumes you use high quality steel lines
with small diameter double braided flex lines.
If using something other than steel the lines tend
to expand and increase pedal travel/work.
"Race Car Braking Systems book
by Paul Lamar and Steve Smith
Steve Smith Autosports
1975"
Paul Lamar
Thanks for all the info. I'm sure that if I take the measurements
from the bike master cylinder, I would be able to make the
calculations to see if it would work.
Regards,
Pierre
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.