Paul,
I was looking at the Sonex site and the info they have regarding their
AeroCarb and AeroInjector products.
Among the items in their FAQ page (
http://www.aeroconversions.com/products/aerocarb/aerocarbfaq.html#aeroinjector_efi
):
"Can I Install the AeroCarb/AeroInjector on a Two-Stroke Engine?
Answer: The AeroCarb/AeroInjector is not a good fit for two-stroke
engines because of their reliance on oil mixed in the fuel for
lubrication, and we do not sell the AeroCarb/AeroInjector for two-stroke
Installation. Back in the 1970s and 80s our company used similar Lake
Injector carbs with much success on the Monnett Moni and Monerais
two-stroke powerplants, but there is significant danger of instantly
seizing-up the engine if the mixture is leaned too much, and we've seen
less-experienced builders do just that. Even setting-up the
AeroCarb/AeroInjector to run a two-stroke engine for the first time is
very perilous, and once running, an instant of over-leaning will
immediately ruin a two-stroke engine."
--end quote --
I'm sure the folks at Sonex would like to sell as many of these units as
they can, so they must have a pretty good reason to tell all those Rotax
owners not to buy this product from them. Now, I know the Wankel isn't
a two stroke, but most of us are counting on oil in the fuel for
internal lubrication. Is there anything about the observation above
that might apply to efforts to build a successful injection system for
our engines? Maybe special considerations to limit the amount of
leaning possible so there's always enough lube entering the rotor
housing under any condition?
Just wondering.
Mark W.
We do it all the time. Most rotaries flying with Tracy's EFI mix
2 stroke oil with the fuel.
I have no idea what their problem is. Perhaps the aluminum
piston is seizing in the air cooled steel bore.
Paul Lamar
Another factoid: Rod Millen ran an RX-7 in Pro Rally in the 80s and
used plenty of 2 cycle oil mixed in with the gas. Not certain if the
oil injection pump was still there but Roddy would not run pure gas,
always mixed in plenty of 2 cycle oil .... and replaced the tip seals
every rally!
SD
He should have been running Iannetti silicon nitride apex seals :)
Dave Lemon lost all coolant in his engine during a race.
He builds engines and sells parts as he is the owner
of Mazdatrix so he kept running to see what would happen.
After a few more laps the engine finally quit.
The rotor housing steel liner had melted through to
the water jacket losing all compression.
Dave removed the silicon nitride apex seals and put them in the
next engine and he is still using them. Silicon nitride apex
seals have a much longer life than the stock cast iron seals.
The Star Mazda guys run stock RX8 engines for ten races a year
for three years with out touching the engines. Mazda rotaries have
won more 24 hour races than any other brand. I have owned six
Mazda rotary powered cars starting in 1973. Several had over
300,000 miles with out overhauling the engines.
Ingersol Rand built some very large rotary engines. They own the
worlds record for the life of an internal combustion
engine at 20,000 hours.
If you take care of them by maintaining the coolant system
and keep clean oil in them they last forever.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.