Paul,
I was looking at the Sonex site and the info they have regarding their
AeroCarb and AeroInjector products.
Among the items in their FAQ page (
http://www.aeroconversions.com/products/aerocarb/aerocarbfaq.html#aeroinjector_efi
):
"Can I Install the AeroCarb/AeroInjector on a Two-Stroke Engine?
Answer: The AeroCarb/AeroInjector is not a good fit for two-stroke
engines because of their reliance on oil mixed in the fuel for
lubrication, and we do not sell the AeroCarb/AeroInjector for two-stroke
Installation. Back in the 1970s and 80s our company used similar Lake
Injector carbs with much success on the Monnett Moni and Monerais
two-stroke powerplants, but there is significant danger of instantly
seizing-up the engine if the mixture is leaned too much, and we've seen
less-experienced builders do just that. Even setting-up the
AeroCarb/AeroInjector to run a two-stroke engine for the first time is
very perilous, and once running, an instant of over-leaning will
immediately ruin a two-stroke engine."
--end quote --
I'm sure the folks at Sonex would like to sell as many of these units as
they can, so they must have a pretty good reason to tell all those Rotax
owners not to buy this product from them. Now, I know the Wankel isn't
a two stroke, but most of us are counting on oil in the fuel for
internal lubrication. Is there anything about the observation above
that might apply to efforts to build a successful injection system for
our engines? Maybe special considerations to limit the amount of
leaning possible so there's always enough lube entering the rotor
housing under any condition?
Just wondering.
Mark W.
We do it all the time. Most rotaries flying with Tracy's EFI mix
2 stroke oil with the fuel.
I have no idea what their problem is. Perhaps the aluminum
piston is seizing in the air cooled steel bore.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.