Subject: How many RX8 owners do we have
From: Rotary Engine
Date: 1/14/2011, 9:34 PM
To: AAA Put this in the To box


 How many people on here have RX8's other than me and Harley?

 Paul Lamar

 I own a 2004, 6 speed.

 Tom

 Have you checked your coils Tom ?

 If not an easier way to get them out is remove
 the strut tower tubular brace that goes across the
 compartment from wheel to wheel first.

 I did not do that and struggled getting the air box
 and intake bellows out.

 I did not take off the throttle body but that
 too would be good idea IMHO.

 I used every shade tree mechanic trick I could think
 of an it is not easy getting them out with out dropping
 a coil hold down nut down into the engine compartment.
 You will be lucky if they fall on the floor :)

 It least one of mine disappeared :)

 Paul Lamar

 We own a 2008 RX8 that my wife owns. Other than tires and oil
 changes we haven't had to do anything to it. Jay

 We are up to five. I know another guy in Florida so that makes six.
 I would check the coils for burn spots every couple of years.

 As far as dropping the nut a magnetic 10 mm socket would help.

 Paul Lamar


 There was a factory recall on this model a couple of years ago, not
sure what
 it was all about; however, the people at the dealership said that
everything
 was fine. Only challenge I have had is with the engine flooding, once
only,
 after I had shut it off before coming up to operating temperature.

 What is this with the coils?

 Tom

 If a coil misfires the rich mixture washes off the apex seal
 oil and the apex seals wear out. When this happens you need a
 new engine. Once 8 years goes by or 100,000 miles the engine
 is out of warranty. You may already have one or two bad coils
 as very little power is lost if both bad coils are trailing.

 The check engine light may not come on. If the check engine
 light comes on stop where you are and have the car towed
 or get an OBD II monitoring device.

 Paul Lamar

 Just curious, is it just as bad if you are mixing in the
 2 stroke oil, or only a problem for those who don't?
 I don't own an RX, but interested in the answer.
 C. Smith

 Mixing 2 stroke oil with the stock RX8 just puts more
 oil there to be washed away. Normally, for aircraft use,
 the oil metering pump is removed and 1 oz per gallon
 of 2 stroke oil is mixed with every gallon of fuel.

 What I have been doing with my RX8 is mixing a 1/2 of an oz
 which is in addition to what ever the metering pump
 is putting in there. I started doing that when I first
 heard of the engine failing. At the time nobody really
 knew what was causing it. Some speculated that Mazda cut
 down on the apex seal oil to meet new HC emissions rules.
 In fact I heard of a rumor where they re-flashed the chip to
 increased the apex oil volume. Mazda then increased the
 engine warranty to 8 years and 100,000 miles. 100,000 miles
 is a pittance for rotary motors as I have had a couple that
 went over 300,000 miles.

 Other's claimed they moved the injector hole position
 in the rotor housing off to the side and added another
 one on the other side. Nobody figured it out until about
 2006. Then apparently the problems was identified but
 not well publicized. Mazda came out with an improved
 coil about 2007.

 When I found out about it I assumed
 Mazda was changing out the coils whenever one took his
 car into the dealer for service. That was not the case
 as the old part numbers were still in my car and in Harley's
 car. Both 2004 models. When Milo dropped off his RX8 engine
 test stand one or more RX8 coils were shot but he had the
 early coils in there. That is when I started looking into
 the situation. Apparently people in the UK discovered
 the real problem.

 The main function of the apex seal oil is to cool the apex
 seal believe it or not :)

 IMHO the whole situation was not handled well by Mazda.

 Paul Lamar


 My 2005 RX8 has only 33,000 miles on it and runs great. Should I test or
 replace my coils?

 Scott

 Absolutely Scott. Do it as soon as possible.

 Paul Lamar


Paul, I commented elsewhere on the MSD thread that a simple coil check
could be done by swapping the HT leads on the leading and trailing
plugs, as  a crook trailing coil may be asymptomatic (apart from
wrecking the engine), a crook leading coil will reveal itself by
obviously impaired performance. Please confirm if this is so as it could
be a quick and easy check.

John Evans

Yes I think that might work on Tracy's installations as I think
he fires both plugs at the same advance angle. It might be bad on
a car as the leading and trailing plugs are fired at different
times and you would be swapping those times. Perhaps causing
detonation. Of course be careful rotor one coil is not connected
to rotor 2 housing.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.