Does it look like the inner oil control seal is gone on this photo? That
would be great to remove if not needed for aircraft, as it would allow the
center port in the center housings to be opened up about .25 inches in diameter.
Be more easier to get oil out of the rotor..............not necessarily
recommending removing both..we talked about this before, but i am trying
to convince dave to think about removeng the inner, don't see any
problems there.......this photo, if i am right, might be some ammo for
an argument to tip him that direction.......I personally would like to
see it gone in the light weight rotor turning over 8000 at cruise........
if a light weight rotor is developed a PSRU to accommodate that rpm has
to be developed. Anything in the 3 to 1 won't work to get full
potential, 4 to 1 minimum maybe more....
I have design for that, but not a planetary....
jeff
No picture came through Jeff. As you know I would remove both as
a little smoke on start up is no worse than a radial engine :)
We might even convert a few radial lovers for nostalgic reasons.
Cuts internal engine friction as well.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.