Subject: oil control seals
From: Rotary Engine
Date: 1/16/2011, 11:34 PM
To: AAA Put this in the To box


 Does it look like the inner oil control seal is gone on this photo? That
 would be great to remove if not needed for aircraft, as it would allow
 the
 center port in the center housings to be opened up about .25 inches in
 diameter.

 Be more easier to get oil out of the rotor..............not necessarily
 recommending removing both..we talked about this before, but i am trying
 to convince dave to think about removeng the inner, don't see any
 problems there.......this photo, if i am right, might be some ammo for
 an argument to tip him that direction.......I personally would like to
 see it gone in the light weight  rotor turning over 8000 at
 cruise........

 if a light weight rotor is developed a PSRU to accommodate that rpm has
 to be developed.  Anything in the 3 to 1 won't work to get full
 potential, 4 to 1 minimum maybe more....
 I have design for that, but not a planetary....

 jeff

 No  picture came through Jeff. As you know I would remove both as
 a little smoke on start up is no worse than a radial engine :)
 We might even convert a few radial lovers for nostalgic reasons.
 Cuts internal engine friction as well.

 Paul Lamar

More than a little oil smoke ;)  See any high mileage 13B with 2 sets of
worn oil scraper rings.
Your engine will be well preserved as it always leaks and burns oil.
It would be cheaper to do a quick rebuild without one or both sets first
to test the idea.

Jeff, what rpm are planning to run?  8000rpm/2.85 ~=2800, well within
standard prop lengths.

Cheers
Cary

Naw no big deal. I ran my Cosmo for 10 years with melted oil
scraper O-rings :) Did not bother my girl friends :)
Both before and after I had it repainted.

I agree with the test and I already proposed it.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.