Now that torsional vibration is being discussed let's get back to the
single rotor version. Does anyone know what would be a satisfactory
torsional vibration damper for these as they don't have the overlapping
power pulses from the other rotor to smooth things out i.e. how much
flywheel do they need?
I note that Richard Sohn uses a Hirth reduction box on his - I think
they use a rubber dough nut like the Rotax 2 stroke reductions?
Are the rubber isolators used by Tracey suitable for the frequencies of
a single rotor, let alone the increased amplitude with no overlapping
power strokes?
It would be nice if the collected wisdom on single rotors was available
in one place, after all about 100 to 120 HP (Rotax 912 to 914 territory)
is commonly needed for very light aircraft. I must admit I'm not all
that impressed with my 912, it only has 29.9 hours on it, the fuel pump
failed - leaked oil, coolant seems to ooze out everywhere, and after all
it still has exhaust valves to fail. I've just discovered a pinhole
exhaust pipe leak that was burning the paint on the engine mount, it's
not that far from fuel and oil lines. Just what I need, an in-flight
fire:( I think my old Subaru E$A 81 is better engineered and cheaper.
John Evans
(Heretic)
I think you are going to have to make your own.
Tracy's system works well for a two rotor but a one rotor
fires half as often. Tracy's system allows the engine to idle
down to 1500 RPM. That should be your target idle RPM.
I would use his general design and increase the diameter
of the rubber bushings and use a lower Durometer rubber.
Silicone rubber is called for as it has a higher heat tolerance.
A lot of heat will be going into the rubber.
You can make the bushings out of silicone rubber sheet
from McMaster. Allow a bit of expansion room.
There may also be an off the shelf off road rear wheel
motor cycle part that might work.
The Centeflex is too stiff and they don't make a much softer
one.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.