Subject: torsional vibration
From: Rotary Engine
Date: 1/16/2011, 7:04 PM
To: AAA Put this in the To box


 Now that torsional vibration is being discussed let's get back to the
 single rotor version. Does anyone know what would be a satisfactory
 torsional vibration damper for these as they don't have the overlapping
 power pulses from the other rotor to smooth things out i.e. how
 much  flywheel do they need?

 I note that Richard Sohn uses a Hirth reduction box on his - I
 think  they use a rubber dough nut like the Rotax 2 stroke reductions?

 Are the rubber isolators used by Tracey suitable for the
 frequencies  of a single rotor, let alone the increased amplitude
 with no overlapping  power strokes?

 It would be nice if the collected wisdom on single rotors was available
 in one place, after all about 100 to 120 HP (Rotax 912 to 914
 territory) is commonly needed for very light aircraft. I must admit
 I'm not all that impressed with my 912, it only has 29.9 hours on
 it, the fuel pump failed - leaked oil, coolant seems to ooze out everywhere, and after all it still has exhaust valves to fail. I've just discovered a pinhole exhaust pipe leak that was burning the paint on the engine mount, it's not that far from fuel and oil lines. Just what I need, an in-flight fire:( I think my old Subaru E$A 81 is better engineered and cheaper.

 John Evans
 (Heretic)

 I think you are going to have to make your own.
 Tracy's system  works well for a two rotor but a one rotor
 fires half as often. Tracy's system allows the engine to idle
 down to 1500 RPM. That should be your target idle RPM.

 I would use his general design and increase the diameter
 of the rubber bushings and use a lower Durometer rubber.
 Silicone rubber is called for as it has a higher heat tolerance.
 A lot of heat will be going into the rubber.
 You can make the bushings out of silicone rubber sheet
 from McMaster. Allow a bit of expansion room.

 There may also be an off the shelf off road rear wheel
 motor cycle part that might work.

 The Centeflex is too stiff and they don't make a much softer
 one.

 Paul Lamar

 Don't forget that the rotors still have longer time per cycle than a
 piston engine. 270* instead of 180* that helps torsional vibration.

 Check Chrysler products for a damper similar to the one in
 Attachement 4. It is used on the drive shaft instead of a U-joint.
 Chrysler 300, Jeep Gr. Cherokee.

 Dale Davies

 Generally that type is too stiff.  The have a resonant frequency around
 2000 RPM. A two rotor is firing 4000 times per minute or
 66 CPS or 66  Hertz in the metric system. The one rotor would
 be half that.

 Paul Lamar

OK, the vibration harmonics go in multiples, so that will not work. How about
the engine mount bushings that you specify for Jeff's plate?

Dale Davies

We use the 2200 size on a thick plate so it is about 12 Hertz.
The gear ratio is 2.85:1.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.