MM Metals very kindly sent me a one foot sample
so I could do a dwg on a RX8 coil heat sink.
It is a bit tricky as the part to be cooled
is in a recess in the bottom of the coil.

Rather than shave off the bottom of each coil there
will be islands that make intimate contact
with the hot part.

RX8 coils have been known to fail so this
is a bit of insurance. I'll try to squeeze
it to fit the stock RX8 car to expand the
market and lower the cost.

Hopefully Jeff will make them and sell
them.

DWG soon.

Paul Lamar