Does it look like the inner oil control seal is gone on this photo? That
would be great to remove if not needed for aircraft, as it would
allow the
center port in the center housings to be opened up about .25 inches
in diameter.
Be more easier to get oil out of the rotor..............not necessarily
recommending removing both..we talked about this before, but i am trying
to convince dave to think about removeng the inner, don't see any
problems there.......this photo, if i am right, might be some ammo for
an argument to tip him that direction.......I personally would like to
see it gone in the light weight rotor turning over 8000 at
cruise........
if a light weight rotor is developed a PSRU to accommodate that rpm has
to be developed. Anything in the 3 to 1 won't work to get full
potential, 4 to 1 minimum maybe more....
I have design for that, but not a planetary....
jeff
No picture came through Jeff. As you know I would remove both as
a little smoke on start up is no worse than a radial engine :)
We might even convert a few radial lovers for nostalgic reasons.
Cuts internal engine friction as well.
Paul Lamar
Thats a heads up for me. I spoke to a recently retired rocketdyne
engineer (name withheld to protect the environment):) at this saturdays
EAA meeting about beryllium/aluminum. He told me the heat conductance is
about the same as copper, rather high. We talked about all the usual
engineering stuff, expansion, weight, etc. Gave me another rendition of
the story of how titanium was about as abundant as aluminum in the
soviet union, and now the old military towns make golf clubs out of it
for lack of another market to sell it in.
He talked about the rotary designs he had seen under development. Stated
the light alloy rotor and end housings would help prevent hot spots in
the engine because the lighter alloys spread out the heat faster than
iron. We also discussed the thin section bearings for the psru.
He gave me his opinion about "nasa" patents, responding to my statement
about nasa 398 alum. Said nasa guys usually patent something someone has
already done, but considered insignificant, and then said I could go to
a foundry that specializes in mixing alloys and get them to mix anything
I want. A post here last week gave us a link to such a place.
I am working on getting a solid works rendering of a rotor design posted
here. It's going to take me a month probably. My hope is that the hyper
active minds here will get together to develop a durable light weight
rotating assembly.
Ed Carver
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.