Does it look like the inner oil control seal is gone on this photo?
That
would be great to remove if not needed for aircraft, as it would allow
the
center port in the center housings to be opened up about .25 inches in
diameter.
Be more easier to get oil out of the rotor..............not necessarily
recommending removing both..we talked about this before, but i am
trying
to convince dave to think about removeng the inner, don't see any
problems there.......this photo, if i am right, might be some ammo for
an argument to tip him that direction.......I personally would like to
see it gone in the light weight rotor turning over 8000 at
cruise........
if a light weight rotor is developed a PSRU to accommodate that rpm has
to be developed. Anything in the 3 to 1 won't work to get full
potential, 4 to 1 minimum maybe more....
I have design for that, but not a planetary....
jeff
No picture came through Jeff. As you know I would remove both as
a little smoke on start up is no worse than a radial engine :)
We might even convert a few radial lovers for nostalgic reasons.
Cuts internal engine friction as well.
Paul Lamar
More than a little oil smoke ;) See any high mileage 13B with 2 sets of
worn oil scraper rings.
Your engine will be well preserved as it always leaks and burns oil.
It would be cheaper to do a quick rebuild without one or both sets first
to test the idea.
Jeff, what rpm are planning to run? 8000rpm/2.85 ~=2800, well within
standard prop lengths.
Cheers
Cary
Naw no big deal. I ran my Cosmo for 10 years with melted oil
scraper O-rings :) Did not bother my girl friends :)
Both before and after I had it repainted.
I agree with the test and I already proposed it.
Paul Lamar
What would be wrong with running a lighter rotating assembly at
7000rpm. Does anyone really know at what point the rotary becomes
inefficient in it's rpm range? Say if we could create a rotor in the
3.5lb range with the necessary light eshaft, and could rev to 17k.
Would we be at an advantage running faster than 7k? We have some
port changing to do if our speed is much higher.
Ed Carver
Well so far it breaths well enough at 11,000 RPM.
Internal friction increases with speed but it has a lot less internal
friction than a piston engine. Formula 1 engines run
up to 19,000 RPM. The Le Mans engine had it's
best BSFC at 6000 RPM where the rotor weight was balanced by the
compression pressure. With a lighter rotor that will happen
a few thousand RPM higher. Since internal friction HP will also be
higher the BSFC is likley to suffer a bit.
I see no benefit in getting more than 250 HP from a 2 rotor
for aircraft use. More HP means more cooling and more fuel
burn. Also we have no real idea how long the engine will
last at higher HP levels. Drag racing is one thing but
3000 hours TBO is another.
IMHO the main use for a lighter rotor is auto racing.
Perhaps Reno if they are dumb enough to put a displacement
limit on the racers.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.