I am wiring one of Tracy's computer to an RX8 engine
    and I need four injector connectors. I have given
    up on the coil connectors and will make my own.

    Does anybody know where I can get RX8 injector connectors?

    Paul Lamar


The connectors I used are Nissan units.  They worked on my 20B 550cc
injectors as well as the new DEKA-IV injectors I am currently using.
Try a Maxima or 300-ZX.  They should be available on ebay.

Mark S.


Thanks for the tip Mark.

I have broken the job down to 5 harnesses. Starter alternator
harness, Sensor harness, Injector harness, Coil harness and PCM
harness. Since it is hard to get wires in more than about 4 or five
colors this makes the job much easier.

Tracy calls out 20 gage wire for most things but it is a bit
hard to work with. I found a roll of 16 gage speaker wire
with four color coded wires in a white vinyl jacket 100 feet
for $30. I'll use this for coil and injector harnesses. For
the low current PCM harness I am using  an old centronics
printer cable.

Since I am using the the terminal strip break outs
for the D sub min connectors on the EC2 and PCM  It cuts the
job down to one or two days for the whole thing.
It is also a lot neater and easier to trouble shoot.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.