I am wiring one of Tracy's computer to an RX8 engine
    and I need four injector connectors. I have given
    up on the coil connectors and will make my own.

    Does anybody know where I can get RX8 injector connectors?

    Paul Lamar


The connectors I used are Nissan units.  They worked on my 20B 550cc
injectors as well as the new DEKA-IV injectors I am currently using.
Try a Maxima or 300-ZX.  They should be available on ebay.

Mark S.


Thanks for the tip Mark.

I have broken the job down to 5 harnesses. Starter alternator harness,
Sensor harness, Injector harness, Coil harness and PCM harness. Since it
is hard to get wires in more than about 4 or five colors this makes the
job much easier.

Tracy calls out 20 gage wire for most things but it is a bit hard to
work with. I found a roll of 16 gage speaker wire with four color coded
wires in a white vinyl jacket 100 feet for $30. I'll use this for coil
and injector harnesses. For the low current PCM harness I am using  an
old centronics printer cable.

Since I am using the the terminal strip break outs for the D sub min
connectors on the EC2 and PCM  It cuts the job down to one or two days
for the whole thing.
It is also a lot neater and easier to trouble shoot.

Paul Lamar

Paul,

I had the same problem and found the injector connectors over here:
http://www.bmotorsports.com/shop/product_info.php/cPath/109_175/products
_id/571

http://tinyurl.com/65lds8f

Ordered Monday and received it today, very fast shipping!

I also can't find the ignitions coil connectors......

Gr. Kevin van der Beek

Can you narrow that link down to just the injector connector?
There are lots of connectors on there.

Paul Lamar