Subject: Makes you go Hmmm
From: Rotary Engine
Date: 1/20/2011, 6:44 PM
To: AAA Put this in the To box


Paul,

Once more you've written an excellent article for Kitplanes, "Makes you
go Hmmm".  However I must disagree with your contention that the e-shaft
does not experience reciprocating forces.  The rotor subjects the
e-shaft to a point loading force that eccentrically contacts the e-shaft
at a different locus as it rotates around it, causing it to bow out like
a jump rope spun between two girls.  The force is also pulsatile in
response to combustion.

While not equivalent to the shock loading experienced by a crankshaft,
the e-shaft does experience a circular reciprocating force, not the pure
centrifugal force of a turbine.

If I may summarize all that I learned from the automobile engine
articles in the February 2011 issue of Kit Planes magazine: amateur
airplane builders fantasize about using automobile engines because they
are cheap due to the economies of scale; have  superior FADEC electronic
ignition and carburetion or fuel injection and burn cheap, readily
available auto gas.

However automobile conversions do not make satisfactory airplane engines
because:

1) auto engine conversion and installation is fraught with difficulty,
resulting an initial high accident rate secondary to engine failure.

2) automobile engines are not engineered to run at constant high power
outputs for prolonged periods of time and consequently suffer frequent
and early fatigue failures limiting time before overhaul (TBO).

3) require the use of a propeller speed reduction unit, another source
of failure.

4) Auto engines have a high weight to horsepower penalty.

5) Auto engines are always used.

Wankel engines are inherently less complex because they have few moving
parts and don't vibrate or fatigue fail due to a minimum of
reciprocating motion (thus have a long TBO) and and have a very high
power output to weight ratio.  Unfortunately they are not certified and
therefore can't be used in manufactured airplanes, nor come in ready to
install firewall forward packages for many kitplanes.

Do to all its advantages, it seems to me that a Wankel engine would make
an ideal generator for hybrid installations



Barry Gloger

Read this and get back to me.

http://www.rotaryeng.net/how-wank-works.html

Some two rotors have a center main bearing.
The shaft is plenty stiff enough with out it for 9000 RPM.
We use 7500 max.

Of course it pulsates but so does any intermittent internal
combustion engine. It pulsates less than a 4 cylinder.
Who cares about certified airplanes?

You are free to offer a firewall forward package
but you would go broke like some others I know.
In some cases the engine is free to the end user. How are
you going to compete with that? We have have had people
buy an engine in the junkyard with 100,000 miles on
it, install it in their airplane and fly it 600 hours.

Paul Lamar



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.