Hi all!
Just picked up an rx8 engine from a former employee at Mazda design in
Irvine.
Attached are few pics of the stuff I removed, believing it to all be
unnecessary, hoping you can tell me what exactly it is I need from it
all. So far as I know, I only need the coils and injectors for the
planed P-port conversion. Everything has less than 100 miles on it. It
was kept on the floor of the garage, along with the rest of the toys
(engines), for the last 6 years or so with the intent to install it in a
76 rx7. I will need the part that the auto trans flex plate bolts to, I
have the flex plate already. It is a 6 port.
Thanks!
Ed Carver
Congratulations Ed. I see the coils are still on the engine.
Pull one off and test it. Also read the part number off
the side. If it is not a 100 B don't use them.
If two coils are bad on the same rotor the engine could
be damaged. Do you know the compression numbers?
The wiring harness for sure must be saved for the connectors.
The metering pump can be sold for big bucks. New ones
are $1500. Separate out that pile and I can see more.
Does it have the rear balance weight? That is what the
flex plate bolts to.
The six port is the 250 HP engine at 8500 RPM.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.