Subject: Tension bolts
From: Rotary Engine
Date: 1/22/2011, 5:06 PM
To: AAA Put this in the To box

In reference
to Perry Mick's broken tension bolt...this was on an RX8?
He was only running at 4500 to 5000 rpm...perhaps
it might be even less reliable at a steady 6000 rpm?
I get the impression that nobody has had such a problem
with other 13Bs?  Actually the 'fix' of drilling larger diameter
bolts could be problematic if it weakens the housing or
encroaches on cooling passages etc.  Thoughts?  Thanks.

Gene Kahn

No 13B.

This problems has been around for years and Mazda changed the
design of the bolts several times. If you put RTV on any
of them problem solved. Heck a few O-rings would work
if you could keep them in position. I think the latest
have a bit of heat shrink tubing located  around the middle.
Could be on the RX8 bolts as I have yet to see one.

It happens when the sustained RPM hits the resonant frequency
of the bolt. That changes to a certain extent by how much you
torque it. Like tuning your violin. What works at 6000 might
not work at 4500.

No problem drilling these out to .500 inch from 10 mm (.3937").
There is plenty of room around the bolts now as they are
not used for locating anything. When drilled out
they do locate everything. Just like 17 dowel pins.

The frequency of the half inch bolts has been moved way up
above the max possible RPM of the engine. Not to mention
they are constrained from vibrating in the violin string mode
by the bolt bores.

They do add a little weight.

I want to make it perfectly clear these 1/2 inch bolts are not
necessary unless you  are asking for over 350 HP from a two
rotor by boosting it.

Paul Lamar



Thanks again Paul.
GK


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.