Subject: Tension bolts
From: Rotary Engine
Date: 1/22/2011, 11:32 PM
To: AAA Put this in the To box


 In reference
 to Perry Mick's broken tension bolt...this was on an RX8?
 He was only running at 4500 to 5000 rpm...perhaps
 it might be even less reliable at a steady 6000 rpm?
 I get the impression that nobody has had such a problem
 with other 13Bs?  Actually the 'fix' of drilling larger diameter
 bolts could be problematic if it weakens the housing or
 encroaches on cooling passages etc.  Thoughts?  Thanks.

 Gene Kahn

 No 13B.

 This problems has been around for years and Mazda changed the
 design of the bolts several times. If you put RTV on any
 of them problem solved. Heck a few O-rings would work
 if you could keep them in position. I think the latest
 have a bit of heat shrink tubing located  around the middle.
 Could be on the RX8 bolts as I have yet to see one.

 It happens when the sustained RPM hits the resonant frequency
 of the bolt. That changes to a certain extent by how much you
 torque it. Like tuning your violin. What works at 6000 might
 not work at 4500.

 No problem drilling these out to .500 inch from 10 mm (.3937").
 There is plenty of room around the bolts now as they are
 not used for locating anything. When drilled out
 they do locate everything. Just like 17 dowel pins.

 The frequency of the half inch bolts has been moved way up
 above the max possible RPM of the engine. Not to mention
 they are constrained from vibrating in the violin string mode
 by the bolt bores.

 They do add a little weight.

 I want to make it perfectly clear these 1/2 inch bolts are not
 necessary unless you  are asking for over 350 HP from a two
 rotor by boosting it.

 Paul Lamar

I have recently seen a broken S4 tension bolt despite really good RTV
spiral beads...
Most of the standard extraction tricks have been tried, waiting for 12"
left hand drill bits to arrive.

The S5 and later bolts are heavier and have a section that is supposed
to deal with resonances.
I would go with several layers of heat shrink instead of RTV.

I've read of several problems with improperly doweled engines.

Cheers
Cary

He does not want to disassemble the engine? I assume it is not leaking
internally?

You mean left hand easy outs to get the broken part of
the bolt out of the front end housing? Why not just weld one up?

How are they improperly doweled?

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.