How may people have wired an EC2?
 How many people need to wire an EC2?
 How many people have wired it more than once?

  Paul Lamar



 Hi Paul

 I've wired our EC2
  Steve Izett
  How did it go Steve? What are your impressions?

 Paul Lamar
 --

Hi Paul

Because I have an electronics background, skills in soldering and a pretty good awareness of modern fuel injection, wiring it up was no problem at all.
A few years back I built a Lotus 7 replica and used a Toyota 4AGE engine which I had to reverse engineer the harnesses from circuits of the WEB that were all in Japanese. This was my introduction to understanding modern injection ignition systems.
I just followed Tracy's instructions.
Now mine is just a temp setup to get it running to prove all systems were working.

It hasn't been tested as far as tuning it at various loads. But it runs and all the inputs and outputs are functioning as per expected.

The main EC2 connector is small and requires me these days to use magnifying glasses.
I would recommend labelling wiring so you know whats what.
For someone with little knowledge of electronics and experience with soldering I suppose it would probably seem daunting.
If someone was not proficient with high reliability soldering I would think that a failure mode could be introduced and in this case I think a builder should employ someone to do it for them.

Cheers

Steve Izett
Perth Western Australia

We are going to take the daunting out with a bit of creativity :)

Cute 7, How's the Glassair coming?

Paul Lamar