Subject: nearly new rx8 engine
From: Rotary Engine
Date: 1/22/2011, 12:12 PM
To: AAA Put this in the To box



Hi all!

Just picked up an rx8  engine from a former employee at Mazda design in
Irvine.

Attached are few pics of the stuff I removed, believing it to all be
unnecessary, hoping you can tell me what exactly it is I need from it
all. So far as I know, I only need the coils and injectors for the
planed P-port conversion. Everything has less than 100 miles on it. It
was kept on the floor of the garage, along with the rest of the toys
(engines), for the last 6 years or so with the intent to install it in a
76 rx7. I will need the part that the auto trans flex plate bolts to, I
have the flex plate already. It is a 6 port.

Thanks!
Ed Carver

Congratulations Ed. I see the coils are still on the engine.
Pull one off and test it. Also read the part number off
the side. If it is not a 100 B don't use them.
If two coils are bad on the same rotor the engine could
be damaged. Do you know the compression numbers?

The wiring harness for sure must be saved for the connectors.
The metering pump can be sold for big bucks. New ones
are $1500. Separate out that pile and I can see more.

Does it have the rear balance weight? That is what the
flex plate bolts to.

The six port is the 250 HP engine at 8500 RPM.

Paul Lamar


I do need the auto trans counterweight. All of the coils are embossed
with the same numbers, see image. The header is stainless and appears
thick enough for the side port. Perhaps I can add a P-port in the
exhaust too. Compression pressure seems good when I rotate the crank,
has the same sound as when you turn over motorcycle piston engine with
the foot crank and the headers off. The plugs are on the oily side, as
are the apex seals, particularly the front rotor.

 From what I can see through the ports and plug holes, the internals
look great.
The metering pump has been removed and will be for sale soon. Guess I
just gotta put bolts in the metering holes and cover the meter pump
mount surface.

Will an rx7 flex plate counterweight work the same? Lots of those around
cheap.

Ed Carver

Much better pictures Ed. Thanks

The coils are the old ones and no good.

Not worth adding a p-port exhaust. It will affect the idle compared
to a p-port RX8. The header will work as is on a pusher. They will not fit upside down for a tractor. You could use it with a 180 bend. The RX7 counter weights will not work. The rotors are not the same weight. Contact Mazdatrix.
Save the throttle body and in there somewhere should be the mass
airflow sensor.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.