In reference
to Perry Mick's broken tension bolt...this was on an RX8?
He was only running at 4500 to 5000 rpm...perhaps
it might be even less reliable at a steady 6000 rpm?
I get the impression that nobody has had such a problem
with other 13Bs? Actually the 'fix' of drilling larger diameter
bolts could be problematic if it weakens the housing or
encroaches on cooling passages etc. Thoughts? Thanks.
Gene Kahn
No 13B.
This problems has been around for years and Mazda changed the
design of the bolts several times. If you put RTV on any
of them problem solved. Heck a few O-rings would work
if you could keep them in position. I think the latest
have a bit of heat shrink tubing located around the middle.
Could be on the RX8 bolts as I have yet to see one.
It happens when the sustained RPM hits the resonant frequency
of the bolt. That changes to a certain extent by how much you
torque it. Like tuning your violin. What works at 6000 might
not work at 4500.
No problem drilling these out to .500 inch from 10 mm (.3937").
There is plenty of room around the bolts now as they are
not used for locating anything. When drilled out
they do locate everything. Just like 17 dowel pins.
The frequency of the half inch bolts has been moved way up
above the max possible RPM of the engine. Not to mention
they are constrained from vibrating in the violin string mode
by the bolt bores.
They do add a little weight.
I want to make it perfectly clear these 1/2 inch bolts are not
necessary unless you are asking for over 350 HP from a two
rotor by boosting it.
Paul Lamar
I have recently seen a broken S4 tension bolt despite really good RTV
spiral beads...
Most of the standard extraction tricks have been tried, waiting for 12"
left hand drill bits to arrive.
The S5 and later bolts are heavier and have a section that is supposed
to deal with resonances.
I would go with several layers of heat shrink instead of RTV.
I've read of several problems with improperly doweled engines.
Cheers
Cary
He does not want to disassemble the engine? I assume it is not leaking
internally?
You mean left hand easy outs to get the broken part of
the bolt out of the front end housing? Why not just weld one up?
How are they improperly doweled?
Paul Lamar
Urk Paul, I hate easy-outs, how do you get them out when they break?
Most of the time when you use a left-hand drill the broken bit comes
spinning out, if it doesn't you may be able to drill it out to tapping
size and possibly retap, it's a "nothing to lose approach".
Just make sure you start drilling on centre, but try to jag the thing
out by being a bit rough.
John Evans
Most people just take the engine apart as the broken tension
bolt usually causes an internal leak of coolant. The engine
hardly notices it as far as running is concerned. Perry kept
flying his airplane with the leak until we found the broken
bolt. Taking off and landing in Palm Springs and putting
more coolant in. Pressurizing the cooling system will find
internal leaks lickity split. I mentioned that in my book.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.