Subject: 2 stroke oil in the oil pan
From: Rotary Engine
Date: 1/26/2011, 6:33 AM
To: AAA Put this in the To box

 I am aware of the fragility of the oil lines used by Mazda from their
 oil metering pump to the point of injection, but is that a good reason
 to do away with the pump for aircraft use? I suppose if you're a belt
 and braces (suspenders) person it might be a good idea to run the pump
 and add oil to the fuel as well. I understand that some 2 stroke oils
 remain mixed better than others so surely the pump could be more
 reliable, particularly if the Antipodean habit of using 2 stroke oil in
 the sump is followed. There seems to be some strange belief out there
 that 2 stroke oils are in some way inferior to the usual heavily
 advertised engine oils that leave all sorts of deposits when burnt.

 John Evans

 That is one good reason but another is mixing spreads the oil
 better in the rotor housing. There is no doubt in my mind
 that synthetic oils, and two stroke oils are in that category, are
 better. If in doubt give it the 500 degree F oven test.
 The apex seals run 500 F at full chat.

 Paul

 Our house is regularly inspected by the neighbor's cat, his name is
 Diesel, but as I don't feed him I haven't any cat food tins. Furthermore
 my courage fails me when I contemplate the oven test you recommend:).
 I'm not sure of its relevance anyway.

 Two stroke oil is designed to burn cleanly and leave minimal deposits,
 some are better than others in this regard.
 "Crankcase" oils on the other hand are not designed to be burnt in the
 quantities required in a rotary so they do tend to leave deposits.
 Antipodean experience shows that under racing (or for that matter road)
 conditions 2 stroke oil is satisfactory in rotaries, and is apparently
 generally used.

 Of course there is the possibility that conditions are different in the
 Southern Hemisphere, perhaps it's Coriolis effect? Seriously, there
 remains the possibility that motor racing does not raise the tip seal
 temps as high as aviation use, but then dyno tuning would be similar to
 aircraft use, so why doesn't 2 stroke oil gum up the tip seals as in the
 recommended oven test?

 I know it's inconvenient to have someone asking these questions, but if
 this site is to have any resemblance to using "scientific method" we
 must be prepared to put up with this and enjoy the challenge of bouncing
 stuff off each other.
 John Evans

John,

Since you don't have a cat and you are not brave enough to
cook some oil I suggest another test.

Heat a small chunk of steel in the oven at 500 F
for half and hour.

Remove the steel.

Quickly Measure the temperature with one of those
low cost infrared thermometers.

Quickly poor a teaspoon of oil on the steel while measuring
the temperature.

Note the temperature of the steel one minute later.

The main function of the 2 cycle oil is to cool the apex
seals.

Try any oil you wish including used cooking oil.

Make sure you test 5 W Mobile 1.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.