Don't forget the temperature factor. You could heat your
steel test wheels to 500 F.
I don't recommend 2 stroke oil in gear boxes. Use high pressure
gear oil. It is designed for that purpose. Tracy is getting away with
high temperature crankcase oil in his gear boxes which is a testimony
for the durability of the Ford planetary set that is used in auto
transmission. Auto TX's normally use ATF which I suspect is needed
for the friction and clutch packs found in auto tx's.
I also don't recommend it's use in the oil pan as two stroke engines
do not have plain journal bearings. 2 strokes use roller and ball
bearings. Oils are designed for specific purposes. Trust the oil
engineers. They know what they are doing.
Paul Lamar
I concur with Paul, trust the engineers. Bean counters is another
kettle of
fish. Automatic oil is I believe a synthetic these days. The
different specks
are for different clutch materials. An old trick was to put 1 qt of
Type F in
the Hydramatics to get the clutches to grab a bit quicker. Kind of like a
shift kit. It had a different friction coeficient than the Dexron. I
would be
inclined to use the appropriate Ford type oil in the PSRU. Due to the
duty
cycle being high in AC use compared to automotive, a fairly large
cooler would
be mandated along with a temp gauge. 250* F is MAX with 200* being
optimum.
Put the too smoke oil in the gas where it belongs and synthetic in
the sump.
Dale Davies
Fair go fellers! Let's keep this a bit rational, where are the clutches
in Tracey's PSRU???
You want me to do the high temp oil film strength testing. Why? That's
already been done in rotaries Down Under for many years with great
success by running them on 2 stroke oil.
I spoke to my Mileage Marathon Champion friend yesterday. He says that
he was advised by Shell Oil Engineers many years ago that 2 stroke oils
were best in rotaries. Perhaps the Oil Engineers do know what's best:).
Look I'm not an Engineer, but even I know that point and linear contact
bearings (as you rightly point out are used in 2 strokes) are more
demanding of their lubricants than plain journal bearings.
One of the surprises of our testing was that the oil film strength of
the 90 gear oil was not higher than that.
I am amazed and disappointed at these intellectually dishonest
objections, they are side issues, If you want to debunk our honest
findings repeat the tests - with heat if you wish, but I doubt if it
will make much difference as as there was plenty of heat generated by
increasing friction as the oil films broke down.
Remember we only went to the trouble of doing these objective tests
because the information was not available. There's plenty of hype out
there to convince the gullible that one brand is better than another but
very little real evidence.
SHOW ME THE EVIDENCE.
John Evans
Nobody said Tracy was using clutches in his PSRU. What I said, or
meant to say, or meant to imply, engine oil is not the best for gears.
John, nobody is forcing you not to use 2 stroke oil in your rotary.
I am just not ready to assume it is better for the rotary "crankcase"
and therefor I am not going to recommend it. If you recommend it
that is up to you. Racing is not exactly like powering airplanes.
Thousands if not hundreds of thousands have been using Mobile 1
in the rotary engine "crankcase" on the street and at the race track.
If 2 stroke really was better why did Idemitsu spend millions developing
rotary engine oil? Why not have Mazda just tell everybody they
need 2 stroke oil for their RX8s?
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.