Subject: sparking to the rotor
From: Rotary Engine
Date: 1/28/2011, 8:47 PM
To: AAA Put this in the To box


 With regards to sparking to the rotor; this is not good. The current
 then
 needs to find a path to continue to ground. It may try through the
 seals or
 through the bearings. That has the potential to cause all sorts of
nasty
 things to go wrong in the engine. Metal erosion or welding which
 would be like
 galling from lack of lube.

 Dale Davies


 Dale, I agree with you. Grounding through the rotor would either jump
 the gap of the eccentric to rotor bearing or one of the gas seals.
 Anyone who ever checked a 12 volt battery with a piece of wire can
 extrapolate what 50,000 volts would do. There is of course the
 possibility that the ground would occur back to the rotor housing near
 the plasma emmiter electrode which is much closer than the rotor
 depression. The resulting damage would then take out the seals. If it
 was restrained to grounding back to it's own case like a spark plug
that
 might work.

 Personally I am waiting for Ford to get their laser ignition in
 production. I would try it in the end housings angled to contact the
 side of the rotor depression and reflect back off that. I haven't got a
 clue how fast you can turn the laser on and off but would lean toward
 leaving it on and using something solid state to enable or disable the
 discharge orifice. I don't know how much energy it would take to
keep it
 lit for 40 degrees of rotation compared to the improvement in BSFC but
 having 3 inches of contact with the mixture should allow much later
 timing and result in lower compression pumping losses.

 george grimes

Guys, interesting that Volkswagen has been sparking to the piston with
no ill effect for several years. I'm not sure if it has been released to
the public yet, but they say it has advantages and no problems with the
discharges.
Bill Jepson


Bill,  If VW used a waste spark type coil with both electrodes on  the
same piston there would be no circuit to the cylinder or rod bearing
just back out the second electrode. I suppose that would be two sparks at
the same time, a quicker burn, and make the limited ignition advance
dictated by the piston being near TDC before a spark can  occur
workable. I wish them well. At least they are trying.

george grimes

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.